Automatic Electric Business Card Cutting Machine 300B Business Card Cutter 90*54mm 220V 110V Heavy Duty Fine-tuning Card Cutter

Product number BG00072

Model: 300B

Product name: Heavy-duty fine-tuning electric business card-cutting machine

Cutting speed: about 2-3 minutes (cutting 100 business cards)

Finished product specification: 90*54mm (right-angle business card)

Positioning plate adjustment range: 1-18mm

Cutting paper thickness: 100 280 grams of paper (can cut film-coated business cards)

Tool life: ≥150,000 times

Use voltage: 220V 50Hz 110V

Machine precision: ≤0.1mm

Applicable paper: length 285 297* width 195 -210mm (suitable for A4 paper)

Machine gross weight: 3.3kg

Special attention: It is recommended not to cut more than 300 grams of paper and PVC and other plastic cards, the blade damage is too large

1) Put the business card A4 paper into the first cut, visually align the center line of the business card paper A with the center of the 3mm-wide cutter in the alignment opening 5, and adjust the knobs on both sides to make the positioning blocks on the left and right sides jam the paper.

2) Turn on the forward cutting switch, and feed the paper into the knife edge for cutting (the hand can put the paper on it and follow the paper

Move until the cut is finished, so the A4 will be cut from the middle)

3) Carry out the second cut, visually align the two center lines of the business card paper B and C with the center of the 3mm-wide tool in the alignment port 5, adjust the knobs on both sides to make the positioning block, block the paper, and use both hands. Put it on the paper like playing a piano, close to the machine, and feed the paper firmly into the knife edge

4)10 business cards can be cut by cutting A4 paper 3 times, the standard is beautiful, the square is not skewed, and the cutting edges are smooth and free of burrs

Operation instructions:

1. Place the printed business card paper (standard A4 paper 210x297mm) on the first paper input port flat on the first paper input port, move the positioning devices on both sides to make them close to both sides of the paper, and push the paper forward to the knife edge, Use the knife edge mark to correct the position of the business card paper, and it will be done automatically after you let go.

2. For the second paper inlet, rotate the first cut business card by 90 degrees and place it into the second paper inlet. Move the positioning devices on both sides to make it close to both sides of the paper. Use the knife edge mark to straighten the business card paper and let go. will be done automatically. Finally, clean up the confetti.

This card-cutting machine is only suitable for 100g to 280g paper, and cannot be used to cut PVC cards and other cardboard.

Note: It is recommended not to cut more than 300 grams of paper and PVC cardstock and other plastic cards,

Otherwise, the device blade may be damaged!